Affected Products & Versions: Xpass D2 Keypad 1.1.0 or lower versions as RS485 slave
Summary
The input number pressed on XPass D2 Keypad shows the wrong number when the device is changed to LSB mode.
The card input number pressed on XPass D2 is fine.
For example, your number 12345 in MSB is shown as a totally different number in LSB.
Solution :
Official FW 1.2.0 upgrade
Caution :
- This resolves the issue when there was an issue with input PIN through the D2 Keypad model when the device is connected to the controller through RS485.
- D2 as a Wiegand device doesn't support LSB - it requires custom FW (Based on D2 FW 1.3.1) - Written on 29 July 2020
- D2 as a Wiegand device LSB support is under discussion with a market requirement BMRR-738